Clutch, need uprated... any ideas?

Insane tuning · Post by **Insane tuning** » Tue May 27, 2008 10:38 pm

I need to run a better up-graded clutch as have a new std one and its not holding out to well and has done about 5K.. looking through the old nismo catologe and on there it list's the CA18DET clutch on the list.. any one run? will a clutch for the CA fitt onto the E15Et?

Cheers
T

TBON12 · Post by **TBON12** » Wed May 28, 2008 12:10 am

What brand is the clutch you have now?

I am using an Xtreme heavy duty clutch,
there site is www.xtremeclutches.com.au

Cherry Boy · Post by **Cherry Boy** » Wed May 28, 2008 3:17 am

It depends on the input shaft size and the diameter of the clutch. if they are the same then it could go on fairly easy. I am pretty sure that the CA's have a hydraulic clutch master cylinder but that wouldn't be much of an issue...I think.

boosted · Post by **boosted** » Wed May 28, 2008 6:25 am

Insane tuning wrote:I need to run a better up-graded clutch as have a new std one and its not holding out to well and has done about 5K.. looking through the old nismo catologe and on there it list's the CA18DET clutch on the list.. any one run? will a clutch for the CA fitt onto the E15Et?

Cheers
T

hi,
e15et has 200mm clutch diameter, ca18det has 225mm ...

greets

BennyET · Post by **BennyET** » Wed May 28, 2008 8:13 am

http://www.npcperformance.com.au/cgi-bi ... nicsclutch

raddavey · Post by **raddavey** » Wed May 28, 2008 11:59 am

Another vote for NPC clutch + not slip yet with 237whp!! And about 4 years old.

N12 Turbo Forums

Clutch, need uprated... any ideas?

Clutch, need uprated... any ideas?

Re: Clutch, need uprated... any ideas?