N12 Turbo Forums

hey fellas just wondering if an engine hose kit for a non turbo e15 will fit a turbo jap spec e15t motor and intake?
i dont need the radiator hoses their fresh, just every other engine hose...
cheers in advanced.

turbo spares in cabramatta have got the non turbo engine hose kit listed in the book but the book only lists the top n bottom rad hoses in the turbo model, no engine/heater/intake hoses?

e15 is cabby so I thinking not, for intake use blue or black silicon elbows,heat should be the same be the same if not just use a longer peace of water hose so it don't kink funky but will get you out of trouble



zoomzoom

I was going to say ebay, bit at $40 for the heater hose... Screw that...
Do you really need to change them ?
I replace most of mine by going down to the local hose and fitting place.... (Not PIRTEK)
The red hoes I used for fuel is rated at 250 PSI a little more that we may need LOL and at $3.50/m
If your not too anal... then the bends dont matter that much.
You can get them on right.

PS..
If you need them because they are leaking ????
I think I have some old ones you can have....