Page 2 of 2
Posted: Wed Jul 11, 2012 1:44 pm
by samual
Yeah right.
Good luck, just make sure its the right kit.
You got bigger balls then me. Brakes is about the only thing I not play around with..
Posted: Wed Jul 11, 2012 2:06 pm
by tassuperkart
There actually not very difficult to Strip/build at all.
Just a matter of laying out the bits as they come out in logical order as a guide to installation.
The parts replaceable, as far as seals and so-on are just stock lines and common to a gajillion other brake parts.
The trick with them is if there is significant corosion or damage to the cylinder bores requiring honing or at worst, boring and re-sleeveing.
Cleanliness and thorough preparation on assembly is the key.
Its fairly hard to have them at the point that they might not work/fail after rebuild but its a task that should not be taken lightly.
L8r
E