TXATEU's 83 exa

Kimmo · Post by **Kimmo** » Mon Apr 14, 2008 9:57 pm

IIRC, you should take note of which way the big ends are and which conrods they belong on during disassembly, so you can make sure they go back on the same way...

Pretty sure it's kinda critical

txateu · Post by **txateu** » Sat Apr 19, 2008 1:19 am

yeah your right kimmo, kinda didn't think about it at the time, learn't from that mistake now though... since then ive taken photos of every little thing i do to make sure it goes back on the right way

Damo · Post by **Damo** » Sun Apr 20, 2008 10:26 am

Kimmo wrote:IIRC, you should take note of which way the big ends are and which conrods they belong on during disassembly, so you can make sure they go back on the same way...

Pretty sure it's kinda critical

The rods and caps (should be), no brainer! They are all marked 1 through 4 with the # side on the exhaust side of the block.

Damo

txateu · Post by **txateu** » Sun Apr 20, 2008 1:23 pm

well its easy now... i assumed i had it right but rather then be lazy i wanted to double check before the engine is back together