N12Turbo.com lanyards are now available! Click here to visit the shop
et disc conversion question
et disc conversion question
hey guys, was looking at finishing off converting my exa from drum brakes to disc, and was wondering if its possible/easier to swap the exa master cylinder for an et master cylinder rather than adjusting the proportioning valve
1984 Exa, T2 turbo, 8psi, adjustable fpr, 850cc injectors, megasquirt 2 ecu, E85 fuel, black dash, black boot and bonnet, 14's wrapped in 215/50 BF Goodrich tyres
Now thats a big display picture
My old exa I created from granny spec to a neat little BRIGHT car: http://forum.n12turbo.com/viewtopic.php?t=3903
Current Car: 2004 Vz SS Ute
Current Car: 2004 Vz SS Ute
EA-73-XA wrote:I know im digging up the past
but is that a good way to sort out bias?
go back a few years on this site and you should find the answer to that
i remember afew years back reading threads by a few of the guy on here that race ets were working on bias worth a look
tits'n' wheels gotta love'em
Bias
I had all the intention of working this one through, but didn't get enough laps in the exa to do it justice. Also the weight distribution of mine was different to a road car, with all the rear weight removed.....So Ben's advice and articles are probably the best start.
C
C