N12 Turbo Forums

hey guys, was looking at finishing off converting my exa from drum brakes to disc, and was wondering if its possible/easier to swap the exa master cylinder for an et master cylinder rather than adjusting the proportioning valve

Now thats a big display picture

It can be done, you have to also change all the lines. That said it will not mean you end up with optimally balanced brakes because the mass distribution of the Exa and ET are different.

C

I know im digging up the past

but is that a good way to sort out bias?

EA-73-XA wrote:I know im digging up the past

but is that a good way to sort out bias?

go back a few years on this site and you should find the answer to that

i remember afew years back reading threads by a few of the guy on here that race ets were working on bias worth a look

I had all the intention of working this one through, but didn't get enough laps in the exa to do it justice. Also the weight distribution of mine was different to a road car, with all the rear weight removed.....So Ben's advice and articles are probably the best start.

C