LT8 sensor question

EA-73-XA · Post by **EA-73-XA** » Mon Oct 03, 2011 7:03 pm

iv attempted a search but to no avail

im gonna wire it up, but before i do i pose a question: what sensors do i need, where can i get them?

iv already threaded an o2 sensor in the exhaust, thats all good,
but im wondering about the Air tempurature sensor and i think there was another.... not sure, i dont have my diag handy

so can anyone shed some light on what i can use.....and where i can get them? jaycar or?

thanks in advance

Post by **15exa** » Mon Oct 03, 2011 7:21 pm

water temp, use standard one.

ait i used a haltech one, around 30 bucks (contact haltech for your nearest distributor.

tps i used a vl one

cas is plug and play if retaining dizzy

zoomzoom · Post by **zoomzoom** » Mon Oct 03, 2011 7:56 pm

get on the microtech wedsite it got all you need to know and more,it's also got apart were you can ask all the question you want from the tecs or ring them like I did the other day best way if you DIYing it
my two bob's

zoomzoom

Post by **shanec86** » Mon Oct 03, 2011 8:14 pm

Yeah i have Lt-8:

Water temp sensor = standard
Air temp sensor = ford falcon (EA i think it was)
Crank angle = standard
TPS = standard if you want just switch or Automatic RB30 if you want variable TPS
MAP sensor = built in
Oxy sensor = you already have..

Really the most important is water, CAS, map and TPS in this case. The Oxy and AIT are just to aid in tuning.