N12Turbo.com lanyards are now available! Click here to visit the shop

help with exa stalling once its at running temp

General chat related to anything N12.
Post Reply
MattoRX7
Posts: 50
Joined: Thu Jan 17, 2008 6:53 pm
Location: adelaide, south australia

help with exa stalling once its at running temp

Post by MattoRX7 »

hey guys my exa starts and runs but when it gets to running temp it stalls and wont start. it doesnt overheat and stalls about a few minutes after starting everytime. any ideas. thanx
User avatar
Timmzy
Posts: 618
Joined: Sun Aug 06, 2006 10:54 am
Location: Melbourne

Post by Timmzy »

DOes it cough and die when it stops? IE is it overfueling?

If its just cutting out I'd be putting my money on the Crank Angle Sensor
Race it.
EA-73-XA
Posts: 205
Joined: Tue Jan 29, 2008 5:38 pm
Location: Gosford

Post by EA-73-XA »

ignition module..... mine did that
T3T4 hybrid, FMIC and MT8 =

EA-73-XA now known as DR-34-MN
User avatar
photoglossy
Posts: 2135
Joined: Wed Aug 02, 2006 10:23 pm
Location: Auckland, NZ
Contact:

Post by photoglossy »

What does it idle at when cold?
User avatar
nz_n12turbo
Posts: 443
Joined: Wed Jan 24, 2007 4:32 pm
Location: new zealand

Post by nz_n12turbo »

water temp sensor under you dizy has packed up or become unpluged would be my thoughts
ziddy0786
Posts: 131
Joined: Mon Dec 27, 2010 9:02 am

Post by ziddy0786 »

I had the same problem it turned out to be the dizzy
So I'd suggest change your dizzy mate and go from there
Post Reply