General chat related to anything N12.
MattoRX7
Posts: 50 Joined: Thu Jan 17, 2008 6:53 pm
Location: adelaide, south australia
Post
by MattoRX7 » Thu Sep 29, 2011 12:17 pm
hey guys my exa starts and runs but when it gets to running temp it stalls and wont start. it doesnt overheat and stalls about a few minutes after starting everytime. any ideas. thanx
MattoRX7
Timmzy
Posts: 618 Joined: Sun Aug 06, 2006 10:54 am
Location: Melbourne
Post
by Timmzy » Thu Sep 29, 2011 5:29 pm
DOes it cough and die when it stops? IE is it overfueling?
If its just cutting out I'd be putting my money on the Crank Angle Sensor
Race it.
Timmzy
EA-73-XA
Posts: 205 Joined: Tue Jan 29, 2008 5:38 pm
Location: Gosford
Post
by EA-73-XA » Fri Sep 30, 2011 1:13 am
ignition module..... mine did that
T3T4 hybrid, FMIC and MT8 =
EA-73-XA now known as DR-34-MN
EA-73-XA
photoglossy
Posts: 2135 Joined: Wed Aug 02, 2006 10:23 pm
Location: Auckland, NZ
Contact:
Post
by photoglossy » Fri Sep 30, 2011 3:51 am
What does it idle at when cold?
photoglossy
nz_n12turbo
Posts: 443 Joined: Wed Jan 24, 2007 4:32 pm
Location: new zealand
Post
by nz_n12turbo » Sun Oct 02, 2011 9:14 pm
water temp sensor under you dizy has packed up or become unpluged would be my thoughts
nz_n12turbo
ziddy0786
Posts: 131 Joined: Mon Dec 27, 2010 9:02 am
Post
by ziddy0786 » Mon Oct 03, 2011 2:25 am
I had the same problem it turned out to be the dizzy
So I'd suggest change your dizzy mate and go from there
ziddy0786