Jap Spec Inlet Manifold - Hose Connections

mystic_20_2000 · Post by **mystic_20_2000** » Fri Jan 09, 2009 2:30 pm

Thanks for the Pic Sash, yeah .. thats the spot ... i only recall one of those on my intake ( might not have noticed the one below it.

where are those 2 going too ???

TOP :

Bottom :

the one that i have on the back goes to a T-peice between the charcoal canister and the boost gauge.

also .. you have another one just below the TPS that is wrapping round to the bottom ( the outlet that points 45 degrees down ) where is that going too ??

your help is muchly appreciated and i will be labeling all the hoses pipes and bits and peices and photoshoping all the images with labels for this forum.

ching_84 · Post by **ching_84** » Sat Oct 31, 2009 11:33 am

Does any 1 know where does this little vacuum hose goes?

[/img]

photoglossy · Post by **photoglossy** » Sat Oct 31, 2009 11:41 am

That goes to your boost sensor, mounted on your firewall

ching_84 · Post by **ching_84** » Sat Oct 31, 2009 12:37 pm

photoglossy wrote:That goes to your boost sensor, mounted on your firewall

My engine is E15E, after going to the workshop to do the replacement of the brake proportioning valve, i found the hose was staying there w/o connecting to anything. And my idling are bad. It shouldn`t be a boost sensor on N/A, rite?

Thank you.

photoglossy · Post by **photoglossy** » Sat Oct 31, 2009 12:41 pm

Nope, the NA motor will just have a plastic cap over it. Looks like you have just lost the cap.

Here is my one

ching_84 · Post by **ching_84** » Sat Oct 31, 2009 3:14 pm

photoglossy wrote:Nope, the NA motor will just have a plastic cap over it. Looks like you have just lost the cap.

Here is my one

Oh, thank you for your quick reply. I think i have to get the hole plug.

Thank you.