N12 Turbo Forums

... about. Not some half assed japcrap peanut-headed baby arsed poofter saloon car engine puffing away at 7500rpm....... No sirrrreee! Listen to this ... engineering "can-do" skill which is a talent that is sorely missing now in the vast majority of motorsport! Along with his obvious driving ...

... would they match? 2, handbrake cables and brake lines to fit? Ben Hewitson mentioned something in his HOW TO, but the parts list, was missing :( 1.Yes they are the same, but still would need to grind back and weld up and change ...

im possibly going to attempt this conversion in the near future, and having done some homework and a bit of research, ... to fit? Ben Hewitson mentioned something in his HOW TO, but the parts list, was missing :( 3, the Distribution Valve.... does this need to be tested with different ...

Unless it is a wideband sensor your ecu is reading from, i would disregard what it says. Besides, a 15:1 ratio would be very hard to get a stable idle out of, unless it is above 1500rpm or so. You either have a exhaust leak pre sensor, or the engine is missing like a bastard!

Damo

... an labeled them so i know were they go an how they hook up but im still not to sure about the accessories. i think there is wire diagram that im missing,

maybe get in habit of doing a ctrl-c before submitting, then you can just ctrl-v to fix if it goes missing.

C

How's that E15ET project going?

I have one too in my garage.

Missing exhaust manifold and MS, fuel pump, and E16 rods.

i dont see the point in people using round allen key bolts? am i missing something? they are always a pain in the arse to do up and get undone compared to normal bolts...

Ok so at the moment fixed the alternator problem (missing 1 low bolt and stripped top tension bolt) retapped and fitted 10mm bollt and replaces blow bolt. It has now been pulled off the road and little intercooler replaced with a 600x300x80 cooler ...

a good tip with ALL internet stuff is to type it first in word (or similar) then copy it to the web, that way you get better spelling and a back up copy for when it goes missing.

-only worth it on longer posts though!

C

Whose not getting any lovin then hey. Mate you must be missing the blue bullet to be going off like that. When you get it up there you can just blow those mother fuckin law unabiding Queensland red neck sons of bitches right off gods green earth. Or ...

Apoparently, the grille needs to be fitted for rego as well.
Wifes ET was defected for having most of the grille bars missing and the original owner just used metal flywire.
It sounds very ghetto but looks surprisingly ok!

L8r
Oracle

Got them to pay up but they never sprayed the full roof just blended the paint that was missing back in.

Which I don't think it quite looks right.

ok so here is my question .........

today i changed the acctuator on a mates tdo5h turbo on his galant now its not boosting hard could that be caused by the accuator rod not being tight enough on the waste gate ???????????

geez m8, you have issues which are near on impossible to suss vbia text. Firstly, the MT-4 will be using the EFI temp sensor ... a test light. If they test ok trace them into the fusebox and check for blown/missing fuses or missing relays. There is an ignition and an accessory relay. Listen ...