N12 Turbo Forums

... I reckon its because the E16i may have a knock sensor. Any other ideas where they could differ? ... e15 N/A and turbo block? Only the turbo oil supply is coming to my mind. Is adding a T-piece to the oil pressure sender a good way to go, to make a turbo oil ...

... anti-lag. This setup requires a working speed sensor so the launch function does not enable while ... strategy due to drilling holes and sealing oil issues...... See, traction control requires ... and these gave up one it got asked the higher pressure question. Additionally, the pipes Im using ...

... 14.7 Have a look at the response curve of a NB sensor in terms of AFR V's Voltage and you might ... they are USELESS! I would equate this to an oil pressure light on the dash that comes on at 2 psi! bewdy! ...

... guage is based on a UEGO or similar WIDEBAND sensor. If notm your wasting your money on what ... of a simple O2 meter in the same league as a oil pressure gauge. By all means, when someone becomes competent ...

Looking to the first picture i suppose it's your oil-pressure sensor switch?

And the black-yellow wiring should be the wiring for your temperature sensor on the cars gauge/in the dashboard?

Just my thoughts

Detonation sensor lives on the back of the engine below the inlet ... in the middle of the block. Sort of looks like an oil pressure sender/switch. They will mess with the ECU to an extent ...

... is out and apart, it was late and forgot about oil pressure guage line and snapped it :x .. arp studs and nuts ... feed line to 10mm and making new fuel rail adding ait sensor to the top of intake just behind tb then off for ...

... 1.5%. :D He did note the leaking aftermarket oil pressure sensor, but didn't write it down anywhere on the report :D And... ...

... on boost than my efi 5L ute. I'll check the sensor, cheers mate. When I get the head off I'll ... the turbo loose I can see the a/f ratio, boost pressure, oil pressure, and exhaust temp. Should make it live a little ...

I think I know what causes the low oil pressure readings at idle... the oil pressure sensor seems to be leaking quite a bit... it's shithouse quality, should've guessed that it will break quickly. I'll have to replace it.

You were right, Damo! The oil pressure sensor did bolt straight up to the oil pump! Oil pressures are the same ...

Unfortunately, the oil pressure sensor has 1 mm bigger diameter than the oil pressure switch, it will not bolt up. I'll have to double check on this though.

... However, I think I have a leak between the sensor adapter and the oil filter, which now is leaking worse because the other leaks have been sealed. :roll: Oil pressures are now as reads: 0.1@900 rpm, 0.5@1100, 3.2@2750, ...

... the spring up (about 1.5 mm tighter), and oil pressures have risen a bit over the range. But at idle the ... I did today. I also found out that the oil pressure sensor adapter is still leaking from the bolts that cover ...

... the spring up (about 1.5 mm tighter), and oil pressures have risen a bit over the range. But at idle the ... I did today. I also found out that the oil pressure sensor adapter is still leaking from the bolts that cover ...