N12 Turbo Forums

progress I have finished the interior replaced the dash the trim repair is done new windscrean is in all new suspension is fitted and body work completed is under the lamps now so when dry I will roll it out and take some snaps P.s. thanks haggard for the rims

I got back onto the Exa after some smalll distractions (eg) soarer but got it back together and it started first try and is puring like a kitten also I have nearly finished the panel work the engine is back to factory as I am taking it over the pits for registration

if it was a coil it would not start at all if when it runs it is smooth at idle it is more than likely not a plug and leads tend to cut out under load or heat i would be inclined to fix what you know is wrong first to save diagnosing somting that may not be wrong but more of a side affect of what ha...

I here they are going to cremate him and use the molten plastic to make jackson dolls so now it's the kiddies turn to play with Michael hahaha

it was hard too see the extent of the damage for the decals the wheel arch was actually pushed in further than the body pannel it tried as best to pull the steel at least back to original position but agreed it is unatractive got the head cheacked and cleaned all surfaces ready to re install

the only thing you will learn from the top of a piston is if they have been replaced or not if you can see somthing that looks like this on the top of the piston .20 or .50 then it is safe to say the piston is replaced if you can not see these numbers stamped it is highly likely there factory if the...

It may help to also to a compression test and cylinder leak down test also test the CO2 levels in your coolant (provided you have that tooling at your disposal

I finnally pulled that guard out

DUDE YOU GAVE ME TEARS that is fucking tops HAHAHAHAHAHA ROFL

the biggest cause of build up of any matter is the simple lack of regular servicing oils coolants filters as for moisture in the underside you got me on that one the only time i saw this was when a poncy prick Dropped his oil and tried to clean the engine by filling it with water and detergent and i...

well I am trying not been a forum user much in the past and never posted pics before that is for sure . Will try to refine my technique. As for our back ground garry is a fully qualified spray painter pannel beater and interior upholster with the last part being his strong point greg is a qualified ...

also it is always the case of the more you try to squeeze performance out of something the less reliable it becomes

good to see the exa getting life brreathed back into it milano still a wrking project also?

wowthis thing looks to have turned into a mission for you dude

well today was perfect nothing could have gone any better day 3 head is off for those following the topic had a massive win i 2 directions today first if all the snapped head bolt was sitting proud of the block and with my magic plier device (not vice grips) wound out buy hand head gasket and bolts ...